Briggs & Stratton 10000 Watt Home Generator System Návod k obsluze stáhnout pdf (Strana 12)

12 BRIGGSandSTRATTON.COM

System Connectors

Except for the power output and grounding connectors, all signal wire connections are made to removable two- or ten-pin

connector plugs. Compare this illustration with your generator to familiarize yourself with the location of these important

connections:

A - 2 Pole Connector Plug

B - 240 Volt Utility — Use to hook up the 240V utility leads

from the transfer switch to the generator.

C - +12 Volt DC, .5 Amp Output — Internal power supply.

D - Remote LED Output — Use this to hook up the remote

LED supplied with the generator. The remote LED will

turn on and off in a series of blinks if certain faults are

detected in the generator.

E - Transfer Switch Communication — Use TxRx and TxRx

GND to transfer switch to monitor transfer switch

functions.

F - Fault Contacts — Use NO, COM and NC to hook up a

siren, light, optional GenAlert, etc. to alert you in case

of a fault. Contacts reverse state (NO goes to NC and

vice versa) upon a fault condition.

G - 10 Pole Connector Plug

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 51 52

Žádné komentáře

Briggs & Stratton 10000 Watt Home Generator System Návod k obsluze Strana 12