Briggs & Stratton 252700 Specifikace stáhnout pdf (Strana 42)

Some Vanguard™ V‑Twin engines are equipped

with the Performance Control™ electronic governor

control system for generator or welder applications.

The electronic governor provides more responsive

governing than a mechanical governor system.

Engines equipped with the Performance Control™

electronic governor control system have no

mechanical governor components. The Performance

Control™ electronic governor control system cannot

be retrotted to mechanical governor engines.

The Performance Control™ electronic governor

control system consists of an electronic control

module, wiring and stop switch harness and a throttle

actuator. The control module is equipped with an idle

down circuit for applications requiring that feature.

By cutting the yellow wire loop, the control module

may be converted to 50 cycle – 3000 RPM generator

applications. The engine must be turned off when

cutting Yellow Cycle loop, then start the engine for the

system to reset the engines RPM for 50Hz cycle.

PERFORMANCE CONTROL™ ELECTRONIC GOVERNOR

Performance Control™ Electronic Governor Wiring Diagram

ALTERNATOR

KEY SWITCH

CARBURETOR

SOLENOID

STOP

SWITCH

TERMINAL

SOLENOID TAB

TERMINAL

STARTER

TERMINAL

SOLENOID

BATTERY

TERMINAL

STARTER

MOTOR

12 VOLT BATTERY

IGNITION COILS

ACTUATOR

REGULATOR/

RECTIFIER

AC OUTPUT

WIRES

IDLE

DOWN

DEVICE

50 CYCLE –

3000 RPM

LOOP

DIODE

DC OUTPUT

WIRE

STOP SWITCH HARNESS

MODULE

DIODE

BLACKGREY

RED

GREEN

YELLOW

BLUE

WHITE

another free manual from www.searstractormanuals.com

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 51 52

Komentáře k této Příručce

Žádné komentáře

Briggs & Stratton 252700 Specifikace Strana 42

Komentáře k této Příručce