Briggs & Stratton 461700 Specifikace Strana 5

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 12
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 4
In the USA and Canada, a 24 hour hot line, 1-800-233-3723, has a menu of pre-recorded messages offering you engine maintenance information.
5
Adjustments
Control adjustments
WIRE
To prevent accidental starting, remove
spark plug wires from spark plugs and
disconnect battery at negative termi-
nal, if equipped with electric starter,
when adjusting controls.
To adjust choke control:
Remove air cleaner. Move choke control to CHOKE or START
position. Carburetor choke should be completely closed. If
not, loosen casing clamp screw. Then move casing, wire and
engine choke lever until choke is completely
closed. Tighten
casing clamp screw. Replace air cleaner.
Choke control adjustment
CHOKE
LEVER
CASING
CLAMP
SCREW
CHOKE
CLOSED
To adjust throttle control:
Remove air cleaner. Move throttle control to FAST position.
Swivel should be against side of quarter circle. If not, loosen
casing clamp screw. Move casing and wire in direction shown
until swivel is against side of quarter circle. Tighten casing
clamp screw. Replace air cleaner.
Throttle control adjustment
CASING
CLAMP
SCREW
CASING
CLAMP
SCREW
SWIVEL
QUARTER
CIRCLE
Carburetor adjustments
The manufacturer of the equipment on which this
engine is installed specifies top speed at which the
engine will be operated. DO NOT EXCEED this speed.
Differences in fuel, temperature, altitude or load may require
minor carburetor adjustment. Air cleaner and air cleaner cover
must be assembled to carburetor before starting engine.
The carburetor on this engine is low emission. It is equipped with
a non adjustable idle mixture jet (see inset) and an idle speed
adjustment screw. Only the idle speed screw is adjustable.
Governed idle has been set to 1750 rpm at the factory.
Adjustments
Start engine and warm up approximately 5 minutes before
adjusting. With engine running, place throttle control in SLOW
position. Rotate carburetor throttle lever against Idle speed
screw and hold. Adjust idle speed screw to obtain 1400 rpm.
Carburetor adjustments
NON-ADJUSTABLE
IDLE MIXTURE
JET
IDLE SPEED
SCREW
THROTTLE
LEVER
Zobrazit stránku 4
1 2 3 4 5 6 7 8 9 10 11 12

Komentáře k této Příručce

Žádné komentáře