Briggs & Stratton 461700 Specifikace stáhnout pdf (Strana 7)

In the USA and Canada, a 24 hour hot line, 1-800-233-3723, has a menu of pre-recorded messages offering you engine maintenance information.

Maintenance

See Maintenance Schedule, page 8. Follow the hourly or calendar intervals, whichever occur first.

Note that more frequent service is required when operating in adverse conditions.

Keep engine and parts clean.

With a brush or cloth, remove grass, chaff or debris from

debris guard or rotating screen daily or more often if needed

to prevent engine damage caused by overheating. Do not

clean with a forceful spray of water because water could

contaminate fuel system.

Rotating screen

Debris guard

ROTATING

SCREEN

DEBRIS

GUARD

To assure smooth operation, keep governor linkage, springs

and controls free of debris.

Linkage, springs & controls

CLEAN

Replace in-line fuel filter. See an Authorized Briggs & Stratton

Service Dealer for correct replacement.

Fuel filter

PART NO. 394358 (WITH FUEL PUMP)

PART NO. 298090 OR 5018 (WITHOUT FUEL PUMP)

FILTER

Drain fuel tank or

close fuel shut-off valve

before replacing fuel filter.

Grass, chaff or debris may clog the air cooling system,

especially after prolonged operation cutting tall, dry grass.

Remove blower housing and clean area shown to prevent

overheating and engine damage.

Air cooling system

CLEAN AREA OF

ALL DIRT AND DEBRIS

.030” (0.76 mm)

WIRE GAGE

RESISTOR

PART NO. 802592

Spark plug

Use only Briggs & Strat-

ton Spark Tester, Part No.

19368, to check for spark.

Replace or clean spark

plugs. Do not blast clean.

Clean by scraping or wire

brushing and washing

with a commercial solvent.

Note: In some areas, local law requires using resistor spark plugs

to suppress ignition signals. If this engine was originally equipped

with resistor spark plugs, use same type for replacement.

Remove combustion deposits.

Remove cylinder heads and cylinder head shields every

100-300 hours of operation. Scrape and wire brush combus-

tion deposits from cylinders, cylinder heads, tops of pistons

and around valves. Use a soft brush to remove deposits.

Reassemble cylinder heads and cylinder head shields with

new gaskets. Turn screws down finger tight, with the three

longer screws, if equipped, around exhaust valve. Torque

cylinder head screws in a staggered sequence to 165 in.-lbs.

(18.65 Nm).





   

Fill in both sides, clip and return to:

Briggs & Stratton Corporation

P.O. Box 1144

Milwaukee, WI 53201-1144 U.S.A.

Your Engine

Type

Code

Model

273688

See any Authorized Briggs & Stratton

Service Dealer. Insist on

Genuine

Briggs & Stratton parts! Non-original

parts may not perform as well and

may void your warranty.

To obtain a complete Parts List of

Genuine Briggs & Stratton Parts for

your engine, fill in both sides of this

order form carefully. We cannot fill

your order without the correct

Engine Model/Type/Code. (Please

allow 3 to 4 weeks for delivery.)

1 2 3 4 5 6 7 8 9 10 11 12

Komentáře k této Příručce

Žádné komentáře

Briggs & Stratton 461700 Specifikace Strana 7

Komentáře k této Příručce

Související produkty a manuály pro Motor Briggs & Stratton 461700